Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterWhy University Park Homeowners Choose Ghost Controls Gate Repair
We provide independent Ghost Controls Gate Repair in University Park, TX, specializing in the AXDP dual swing, ASXP single swing, and SLXP sliding opener lines. Most Ghost Controls repairs here come down to two things: limit switch drift from our shifting clay soils, or water intrusion into the motor housing after a hard Dallas storm. We fix both in your driveway, usually same day, and we’re not affiliated with Ghost Controls, which means we tell you the truth about what’s worth repairing and what isn’t. Call (936) 296-2568 and a live person answers, any hour.
University Park is its own animal when it comes to gate work. Nearly every home sits behind an automated ornamental iron gate on a circular or courtyard driveway, and the opener under that gate is often a Ghost Controls unit somebody installed when the house was built or renovated. Hal Gatewood grew up not far from Goar Park and has been providing Dallas Ghost Controls service since 2001. He knows the streets, the home styles, and the particular way Ghost Controls openers behave on heavy custom iron fabrications. We don’t send a call center. You call, you get us.
Why Trust Gatewood Fence & Gate for Your Ghost Controls Gate Repair?
Ghost Controls openers are solid machines, but they have their own personality. The AXDP dual swing series runs two actuator arms off one control board, and when one leaf stops traveling correctly, the problem is rarely the arm itself. It’s usually the limit switch drifting out of calibration or a capacitor on the board that took a hit during a power surge. A tech who doesn’t know Ghost Controls will blame the gearbox and sell you a new opener. We’ve seen it happen in University Park more times than we’d like. Hal’s first question is always the same: show me what it’s doing, and I’ll show you where it’s failing.
We use OEM Ghost Controls circuit boards, motors, and remotes when the gate’s age and condition call for it. But we’ll also install a quality aftermarket limit switch or capacitor when that’s the more durable fix, and we’ll tell you which we’re doing and why. Every job carries our 90-Day Done Right Promise in writing, not buried in fine print. If it’s not right, one call brings us back. Hal’s name is on the shop and on every invoice. The shop is down the road, which is the oldest accountability there is.
Common Ghost Controls Gate Repair Problems We Fix in University Park
Below are the Ghost Controls failures we see regularly on University Park driveways. If yours is doing any of these, call us. We’ll diagnose it on site, not over the phone with a guess.
- AXDP dual swing gate opens one leaf fully, the other only partially. The most common cause is a stripped gear inside one actuator arm combined with a limit switch that’s drifted out of alignment. The board keeps telling the arm to travel, but the gear slips, so the leaf stops short. We replace the gear, recalibrate both limits, and test the safety loop so both leaves cycle evenly.
- ASXP single swing opener trips the breaker or won’t start after a storm. Ghost Controls ASXP motors sit low on the gate post, and the shaft seals wear over time. Water gets into the motor housing, and either the capacitor fails or the windings short. If it’s just the capacitor, that’s a quick fix. If the windings are shorted, that’s when we tell you the honest answer: replace the opener.
- Remote range drops to ten feet or less. That’s almost always antenna corrosion or GateLink wireless interference. The antenna on Ghost Controls receivers sits exposed on the control board, and Texas humidity plus sprinkled irrigation water corrodes the connection over time. Sometimes it’s a neighbor’s new GateLink intercom on a close frequency. We track it down and fix the cause, not just hand you a new remote.
- SLXP sliding gate hums but doesn’t move. A humming motor that won’t turn usually means the start capacitor has failed or the gearbox has seized from lack of lubrication on the drive chain. If it’s the capacitor, we replace it on the spot. If the gearbox is gone, we’ll show you the evidence before recommending replacement.
- Gate stops short of fully open or slams past the closed position. This is classic limit switch drift. University Park’s expansive black clay soils shift gate posts seasonally, which throws off the travel limits on any opener, but Ghost Controls units seem particularly sensitive to it. Realigning the limits takes about an hour, but if the post has moved, we may need to reset it first. A gate sags in the hinge post, not in the middle, and that’s where we start.
Ghost Controls Parts & Our Repair-vs-Replace Approach
We stock the Ghost Controls parts that fail most often: control board capacitors, limit switch assemblies, actuator gears for the AXDP and ASXP lines, remote transmitters, and GateLink intercom modules. If we don’t have it on the truck, we can usually have it by the next morning. For older Ghost Controls units where the OEM board is no longer produced, we use quality aftermarket components that match or exceed the original spec. We’ll tell you which part we’re using and why, and the price is agreed before any work starts.
Here’s our rule on repair versus replace: if the motor windings are shorted or the gearbox is beyond economical repair, we say so plainly and quote you a new opener. If it’s a capacitor, a gear, a limit switch, or a seal, we fix the part. We don’t recommend full replacement just because it’s an easier sale. Hal has been doing this since 2001, and a repeat customer who calls us again in five years is worth more than a commission on an opener somebody didn’t need. Call (936) 296-2568 and we’ll give you the straight answer.
Our Ghost Controls Service Process - Step by Step
- 1
Diagnosis on site. We arrive at your University Park driveway, watch the gate cycle, check limit switch calibration, test capacitor readings, and inspect the actuator arms and seals. We don’t quote a repair until we’ve seen the gate move.
- 2
Written price before work starts. The quote covers parts and labor, and it’s the price you pay. No trip charge inside the county, and $40 off any repair over $200.
- 3
Repair or install. For Ghost Controls units, that means replacing gears, capacitors, limit switches, seals, boards, or full openers. We also handle keypad entry additions, GateLink intercom wiring, and electric gate motor repair on swing and slide systems.
- 4
Test and calibrate. We run the gate through full open and close cycles, set safety loop sensitivity, check remote range from the street and the house, and confirm the auto-close timing if you use it. We don’t leave until the latch catches clean and the opener cycles without a hiccup.
- 5
90-Day Done Right Promise in writing. If anything we touched fails within 90 days, one call brings us back. That’s not a courtesy. It’s the deal.
Ghost Controls Products We Service & Install in University Park
We work on the full residential Ghost Controls lineup: the AXDP dual swing gate opener series, the ASXP single swing series, and the SLXP sliding gate openers. We also install and service GateLink wireless intercom systems, adding keypad entry to existing Ghost Controls setups when you want a code for the landscaper or a nanny rather than handing out remotes. If you’re building a new gate or replacing an old opener in University Park, we can quote a Ghost Controls system or walk you through how it compares to LiftMaster, Viking, and FAAC for your specific gate weight and driveway layout.
We Also Service These Brands
Ghost Controls is one of nine brands we’re certified to service. We also provide Gate Repair on LiftMaster, Mighty Mule, and DoorKing openers regularly across University Park and the surrounding Dallas neighborhoods. That matters because when a Ghost Controls board fails and you’re weighing a repair against a brand change, we can give you an honest comparison based on what we’ve actually fixed, not a sales sheet.
FAQs - Ghost Controls Gate Repair Service in University Park
No. We’re an independent Ghost Controls service in Plano and University Park. We’re not affiliated with the manufacturer, and we don’t pretend to be. What we are is experienced: Hal has been repairing Ghost Controls openers on University Park driveways since they started showing up on local homes, and we know these machines inside and out. Independence means we work for you, not for a brand’s warranty department.
We use OEM Ghost Controls circuit boards, motors, and remotes whenever they’re compatible with your gate’s age and the repair makes sense. For failure points like limit switches and capacitors, we’ll install a quality aftermarket part if it’s the more durable fix. We tell you which we’re using and why before we do the work.
Most common Ghost Controls repairs in University Park, like limit switch recalibration or capacitor replacement, are done in one to two hours on site. Gear replacements on an AXDP actuator arm take slightly longer because the arm has to come off the gate. We carry the common failure parts on the truck, so if your gate is doing something we see regularly, we can usually fix it the same day. Call (936) 296-2568 and we’ll give you an honest window.
We service the AXDP dual swing series, the ASXP single swing series, and the SLXP sliding gate opener line. We also work on GateLink wireless intercom units, including adding keypads to existing Ghost Controls systems. If you have an older Ghost Controls unit that’s been discontinued, we can still usually source parts or recommend a suitable replacement.
If your Ghost Controls opener is still under the manufacturer’s warranty, an independent repair won’t automatically void it, as long as the work isn’t the cause of a later failure. But the honest answer is that most Ghost Controls openers we see in University Park are five to ten years old and well past warranty. On the rare newer unit still covered, we’ll help you weigh a warranty claim against the speed of a same-day repair and let you decide. Call us and we’ll walk you through it.
Ghost Controls gate repair in University Park typically runs $180 to $340 for common fixes like limit switch recalibration, capacitor replacement, or a single actuator gear. Full opener replacement on an AXDP or SLXP system runs higher, depending on gate weight and whether we’re reusing your existing arms and posts. Every price is quoted and agreed before any work starts, and we offer $40 off any repair over $200. Call (936) 296-2568 for an exact quote, estimates are free.
Book Your Ghost Controls Service in University Park, TX
Your Ghost Controls gate is the first line of your University Park home, and when it’s acting up, you want someone who answers the phone and shows up. Call (936) 296-2568 and you’ll get a live person, any hour, any day. Hand me your number and I’ll call you back, same day, every time. We’ll come out, find the failure, and fix it right.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving University Park since 2001.