Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
FAAC Keypad & Intercom Repair: The University Park Owner’s Guide
FAAC keypad and intercom repair in University Park typically runs $185 to $420 installed, depending on whether we’re fixing the wiring, replacing a keypad membrane, or swapping the intercom board. Most jobs we handle same day because we keep common FAAC repair parts on the truck. The usual story we hear goes like this: the keypad worked fine at the driveway yesterday and today it’s dead, or the intercom crackles so bad your guest can’t hear your voice over it. Sometimes the codes drift. Sometimes the buttons stop taking. Either way, you’re standing at the gate in the University Park heat wondering if you’re locked out of your own driveway.
Key takeaways:
- We repair FAAC keypads and intercoms on site, in University Park, usually the same day you call.
- We stock FAAC-compatible parts so we’re not running back and forth to a supply house.
- The price is pinned down and agreed before we touch a wire. Written on the invoice. No surprises at the tailgate.
- Every repair carries the 90-Day Done Right Promise. If it acts up again, Hal comes back and makes it right. No runaround.
Which FAAC Models This Applies To
This repair covers most FAAC gate systems you’ll actually see in University Park: the 400 series (412, 422, 455D), the 750 and 760 swing gate operators, the 390 and 391 slide gate boards, and the older 620 and 750S units that are still running out here. FAAC keypads generally fall into two camps. There’s the flush-mount digital keypad (usually a DigiKey or DigiCard style, wired into the control board) and the newer wireless keypads that pair to the receiver. Intercoms range from simple two-wire audio stations to the multi-tenant panels you see on some newer University Park homes.
One compatibility gotcha we run into constantly: the FAAC wireless keypads shipped with the 455D and newer 750E operators use a rolling code receiver. An older fixed-code FAAC keypad will not talk to a rolling-code board, no matter how many fresh batteries you put in it. People burn whole weekends on that. We check the board revision and the keypad model together before we quote anything, because throwing a new keypad at an old board (or the other way around) is money down a hole.
FAAC OEM parts are well made, but the aftermarket DigiKey style keypads we source hold up just as well for about half the money. The one exception is the intercom audio transformer. Buy the OEM one. The cheap aftermarket transformers buzz on the 455D boards and you’ll hear it every time someone pushes the button.
Signs Your FAAC Keypad & Intercom Repair Is Failing
- Keypad works but the gate doesn’t move. This is usually the relay on the control board, not the keypad itself. The keypad beeps, the code registers, but the board never sends power to the operator. We trace that in minutes with a meter.
- Buttons work on the second or third press. The membrane on FAAC keypads wears out from sun exposure and finger oil. Early on it’s a nuisance. A few months later you’re typing your code four times. The fix is a new membrane or full keypad face.
- Intercom audio hums or crackles constant. Commonly a failing transformer or a corroded connection at the speaker. University Park humidity and rain find their way into outdoor stations, even the ones under a cover. The board might be fine. We fix the wiring and you’re hearing clear again.
- One or more buttons are dead entirely. That’s the button matrix starting to go. It’s almost never worth repairing individual buttons on a FAAC keypad. The membrane is one piece, and once the conductive traces break down, they’re gone. Swap the keypad, keep the housing.
- Gate opens on its own or won’t close without holding the button. Sounds like a safety sensor problem, but a shorting keypad wire can send phantom open signals to the board. We see it on FAAC slide gates that have had a weed eater run through the low voltage line.
Replacement Cost & What’s Included
Here’s the straight University Park pricing on what we typically see:
- Keypad repair (membrane, faceplate, wiring): $185 to $265 installed.
- Full keypad replacement (aftermarket, FAAC-compatible): $240 to $340 installed.
- Intercom audio board repair: $220 to $350 installed.
- Intercom panel replacement: $310 to $420 installed.
Your price lands in one of those ranges based on what we find when we open the panel. Wire damage from University Park’s famously intolerant clay soil and tree roots pushes the number toward the top end. A clean keypad swap with good wiring pulls it down. The quote is written before we start, and it’s the number on the invoice. Period.
Every repair includes the part, the labor, rewiring within the panel if needed, and a full function test of the operator and safety edges. If the gate doesn’t cycle clean a week later, that’s on us. The 90-Day Done Right Promise is on the paperwork, not whispered over the phone.
DIY or Call Us?
There are two safe things you can check before calling. First, confirm the keypad has power. On a wired FAAC keypad, the LED should glow when you press a key. On a wireless keypad, a dead battery is a $5 fix. Second, check the breaker feeding the operator. Beyond that, this part involves low-voltage wiring tied to a control board that runs your whole gate, and there are live AC lines inside the operator housing. That’s the part where we’d rather you not go poking around. A wrong wire on a FAAC board can fry the board, and a board is a lot more money than a keypad.
Call us at (936) 296-2568 and we’ll have someone out the same day in most cases. The price is agreed before the panel comes open.
FAQs
A FAAC keypad on a west-facing University Park gate column lasts about 5 to 7 years before the Texas sun kills the membrane or the codes start drifting. Wireless keypads eat batteries faster here because they sit in the heat, but the pad itself usually survives longer than a wired membrane. A covered keypad can go a decade without a hiccup.
Call (936) 296-2568 and we’ll match your FAAC keypad to the right part and have it turning over the same day.
Yes, more often than not. If the issue is wiring, a corroded connection, or a membrane that just needs replacing, we repair it on site. If the button matrix itself has failed, replacement of the keypad face is the honest answer because repairing individual buttons on a FAAC membrane never lasts. We’ll tell you which bucket you’re in before we quote anything.
Call (936) 296-2568 and we’ll give it to you straight over the phone and put eyes on it the same day.
Most FAAC keypad repairs and intercom swaps finish in under an hour once we’re on site. Repairs that involve tracing wiring back to the control board can run a little longer. Either way, you’ll know the timeframe and the price before we start, and we don’t leave until the gate cycles clean and the intercom sounds like it should.
Call (936) 296-2568 and we’ll schedule a window that actually sticks, which matters out here in University Park traffic.
We keep the most common FAAC keypad membranes, aftermarket keypad units, intercom audio transformers, and wire connectors on the truck. For less common control boards or intercom panels, we can usually have the part in hand within a day or two. University Park homeowners also get the standing offer of a free second opinion on any written estimate.
Call (936) 296-2568 and we’ll tell you right now whether the part you need is on the truck or a day out.
Gatewood Fence & Gate is an independent service provider. We are not affiliated with FAAC, but we’ve serviced FAAC equipment for over two decades, alongside LiftMaster, Mighty Mule, Ghost Controls, and the other gate brands University Park homes run on.
Contact
Hand me your number and I’ll call you back - same day, every time. If your FAAC keypad or intercom is acting up, call (936) 296-2568 for a free estimate. A live person answers, 24 hours a day. We’ll talk through what’s happening, give you a straight price range, and get it fixed before the next University Park dinner guest has to honk at the gate.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving University Park and nearby areas.





Before
After
Before
After
Before
After